Can I undo actions during the Design step?

Yes. You can use the undo/redo buttons available in the interface at any time.

Can I adjust the border reinforcement?

Yes. In the Manufacturing Settings during the Design step, you can increase or decrease the border reinforcement thickness.

Can I adjust the contact points while modeling?

Yes. In the Design step, you can adjust contact points using the manipulators and the "Antagonist Contacts" slider (abrasion, deformation, or in between). Minimum occlusal and proximal distances are respected. Contacts are displayed in color in the Colormap panel.

Is the minimum thickness checked? Can I adjust it?

Yes. The minimum thickness for the selected material is maintained throughout design. Circle One alerts you if the prosthesis is not insertable at the chosen minimum thickness, and offers three options: auto-adjust, manual correction, or continue without correction. You can adjust the minimum thickness in the Manufacturing Settings or in "My Design Preferences." Thin areas are visualized in the Colormap panel.